Husqvarna AUTOMOWER 535 AWD Operator's Manual page 28

Weather timer is reset if the product
Note: The
does not operate for more than 50 hours, or if a
Reset of all user settings is done. The Weather
timer is not changed if a Reset of schedule
settings is done.
To set the Weather timer
Settings > Operation in the app.
1. Select
on/off to enable or disable the
2. Select
Weather timer .
Note: If the cutting results are not
satisfactory, the cutting time can be
adjusted. Set the cutting time
Low to cut for a shorter
a longer time or
time.
Save .
3. Select
3.12.2.2 ECO mode
ECO mode is activated, it switches off the
If
signal in the boundary loop, the guide wire and
the charging station, when the product is parked
or is charging.
ECO mode to save energy and avoid
Note: Use
interference with other equipment, for example
hearing loops or garage doors.
Note: To start the product manually in the work
area, push the STOP button before you remove
the product from the charging station. If not, the
product can not be started in the work area.
To set the ECO mode
Settings > Operation in the app.
1. Select
on/off to enable or disable the ECO
2. Select
mode function.
3. Select Save .
3.12.3 Installation
Installation you can change the
In
installation settings of the product. To
change the settings, obey the
instructions in the Automower
Connect app.
28 - Installation
3.12.3.1 To find the charging station
The product can be set to search for the charging
station in 3 methods:
Charging station signal
•
Follow boundary wire
•
Follow guide wire
•
The factory setting is set to use the 3 search
methods at the same time. Use the factory
setting to find the charging station as fast as
possible and to keep the risk of tracks on the
lawn to a minimum. The product always starts to
search for the
specified time interval, it also uses
High to cut for
Follow boundary wire .
and
Causes why the product cannot follow the wire:
• Obstacles near the wire have not been
isolated.
• The charging station, the boundary wire or
the guide wire are not installed according to
the instructions in
the charging station on page 16 , To examine
where to put the boundary wire on page 17
and in
wire on page 21 .
To change the signal range of the charging
station
For some installations it is necessary to decrease
the signal of the charging station. For example
when the charging station is put near an obstacle
such as a bush or wall and the signal reaches to
the other side of the obstacle. The product knows
that it is close to the charging station and tries to
dock, but the objects prevents it. The options are
min , avg (average) or max .
Note: It is usually better to move the charging
station, than to decrease the range of the
charging station signal.
1. Select
station in the app.
2. Select signal range.
3. Select
To set the delay time for the guide wire and the
®
boundary wire
1. Select
station in the app.
2. Select
the wire.
Charging station signal . After a
Follow guide
To examine where to put
To examine where to put the guide
Settings > Installation > Find charging
Save .
Settings > Installation > Find charging
on/off to enable or disable to follow
1427 - 002 - 20.12.2019