Rivet Spinning - Stihl NG 7 Instruction Manual

English
4
Place the die block (4) on the base
N
plate.
Position the chain on the die block –
N
the cutter concerned must face up
and the tie strap must be in the
appropriate recess, e.g. 3/8" Rapid
chain in workholding recess marked
3/8R or 3/8.
12
Bring down the handle (5) until the
N
punch (1) touches the rivet – the
rivet must be centered under the
punch.
Pull the handle down to press the
N
rivet head out of the link.

Rivet Spinning

WARNING
Impermissible combinations of cutters
and/or chain links may increase the
5
kickback tendency of the saw chain –
risk of injury.
To reduce the risk of injury from the
sharp cutters, wear protective gloves
when working with the saw chain.
1
Selecting Spinning Head and Thrust
Screw
Select the spinning head and thrust
N
screw to suit the chain pitch.
Chain pitch
1/4" P
1/4", 3/8" P, .325" C
3/8", .404"
1/2", 15 mm
A
Marking
Spin - Thrust
ning screw
head
D D
C
A A, B
B A, B
NG 7