Table of Contents
Advertisement
Pulse input
A+
B+
A-
B-
+
-
+
-
Phase A Phase B
4. USAGE PRECAUTIONS
(1)
For wiring to the terminal block, refer to the manual of the programmable controller module to be
connected, published by Mitsubishi Electric Corporation.
(2)
Ground the FG wire provided with the cable in the same manner as the programmable controller
module. Note that rolling up extra wire without grounding the wire may cause the wire to function
as an antenna, resulting in the risk of noise.
This product has been manufactured as a general-purpose product for general industry
applications, etc. The product is not intended for use in devices or systems used under
conditions in which human life could be greatly affected.
When considering application of this product to special applications, such as nuclear power,
electrical power, aerospace, medical, or manned transport devices or systems, contact our
sales service desk.
Although this product was manufactured under a strict quality management system, the product
shall be systematically provided with backup and fail-safe functions when applied to equipment
that may lead to a major accident or damage in the unlikely event any failure or defect should
occur in the product.
MITSUBISHI ELECTRIC ENGINEERING CO., LTD.
1-13-5 Kudankita, Chiyoda-ku, Tokyo, Japan 102-0073
Homepage URL:
http://www.mee.co.jp/
Direct any technical inquiries to:
Nagoya office (PC Engineering Dept.) Phone: +81 (52) 723-8058 Fax: +82 (52) 723-8062
During product use, be sure to ensure safety in the unlikely event failure occurs. Mitsubishi Electric
Engineering assumes no responsibility whatsoever for any secondary damage caused by the failure of this
product.
50D-FB0035 (0906) MEE
For Your Safety
Information such as specifications is subject to change without notice.
16
Developed June 2009
Hide quick links:
Advertisement
Table of Contents
