Water Supply Container; Ice Tray - Hitachi R-G420KHL Instruction Manual

Water supply container

Remove the water
1
supply container,
and then the lid.
Take up the near side of the lid
toward in the direction of the
arrow, and then remove it.
2
Remove the gasket
from the lid and then
the case.
Turn the case and remove it
from the lid.
3
Remove the water filter
from the case.
Pinch the tab of the water filter with
fingers to unset it from the fork, and
then remove the case.
4
Rinse each part of the water supply
container in water.
Wash it with a soft wash sponge etc.
Do not use the detergents etc.
Notice
● Replace the water filter normally every 3 - 4 years.
5
Attach each part to the water supply
container, pour water
in and then set it.
Insert the lid from its rear side and
close it in the direction of the arrow.
Notice
If you intend not to use the Automatic Ice Maker for an extended period of
time, care the water supply tank, dry it adequately, and replace it in a prede-
termined position (dry out the water filter, among others).
BB0055761Y_R-G420KH_A.indd 59

Ice tray

Once a week
1
2
Lid
Gasket
Case
Water filter
Water supply
container
3
Fork
4
Tab
5
Pg.66
6
Once or twice a year
Touch button on the Control
Panel to turn on the indicator lamp.
All indicator lamps turn on, and then the current settings are displayed.
Touch button to
turn on " Off " indicator lamp.
It stops water supply to the ice tray.
※ When " Off " indicator lamp blinks,
wait for about 1 minute for it to turn
on, and then follow the next steps.
Note that the frame cannot be pulled out.
Open the door of the Ice Compartment,
and take out the ice tray.
Push the level laterally. draw the frame.
Raise the cover ( ▲ part) in the direction of the arrow.
Remove the ice tray from the frame.
Ice tray
Cover
Frame
Empty the ice tray and wash
it lightly in the stream.
Do not use a sponge / cleanser, etc.
Be sure not to scarify.
Open the Ice Compartment, and then
attach the ice tray.
Set the ice tray and
close the cover.
Make the frame horizontal and push it into the end, and
Pull up the lever.
(Move the frame back and forth to check that it is fixed securely.)
Click
Is the lever in
Notice
horizontal state?
● When the frame for the ice tray cannot be pushed into the back,
the motor that drives the ice-tray may have operated. Remove
the ice tray once and then push the frame alone into the back,
and then touch button with all the doors closed to turn
on " Off " . After 1 minute, the ice-tray driving motor gets ready,
allowing you to mount the ice-tray.
Touch button on the
Control Panel to turn on the
indicator lamp, and then touch
button to turn on the
" On " indicator lamp.
Automatic Ice Making starts.
Light ON
Touch it
Lever
Click
Horizontal
Light ON
Touch it
59
19/11/08 9:08