Advertisement
5. Separate the slides prior to attachment.
You can not attach the full extension ball bearing drawer slides
to the drawers or cabinet until you separate them into two
halves. As you pull them apart, push down on the little black
lever. In the photo to the right, the operator is pushing down on
the black lever with his right index finger.
6. Slides separated.
In this photo you can see what the slides look like separated.
The slide half in the operator's right hand attaches to the drawer.
The slide half in the operator's left hand attaches to the cabinet.
Do not mix this up! Note: there is no left or right orientation.
The slides work both to the left or right in the same way.
7. Attach the (4) slide halves to the drawers.
Use (3) #8 x 1/2" pan head screws for each slide half, as shown.
Repeat for the other three drawer slide halves. Center the
screws in the slots, as shown below. Be sure to position the
front of the slide halves to the front of the drawers! There is
no left or right orientation.
#8 x 1/2" pan head screw
front
Center screws in these slots only!
8. Attach the (4) slide halves to the cabinet.
Use (3) #8 x 1/2" pan head screws per slide half. It will be easier
to install the slides if you lay the cabinet down on its back, as
shown. Be sure to position the front of the slide halves to
the front of the cabinet! There is no left or right orientation.
rear
Put screws in these holes only!
rear
front
Page 3
5
6
7
8
Advertisement
