Table of Contents
Advertisement
2.3
Noting the identification information
2.3
Procedure
1. Write down the Microsoft Windows Product Key of the Certificate of Authenticity COA in
2. Write down the manufacturer's number SVP and the order number , e.g. "6AG71...", in
Figure 2-1
3. Write down the Ethernet address of the device: The Ethernet address is located in the
Identification
1
Microsoft Windows Product Key
2
SVP number
3
Order No.
10
Ethernet address
Panel PC IL 77
QuickStart, Edition 10/2004, A5E00327597-01
the table at the end of this section. The product key can be found at the back of the
device. You will need the product key during the reinstallation of the operating system.
the table. If repairs are necessary, the device can be identified by the service center on
the basis of the SVP number and order number.
Both numbers can be found on the rating label attached to the side of the device where
the power unit is located.
Rating label of the device, for example
"Main" menu of the BIOS setup, "Hardware Options > Ethernet Address."
Unpacking and connecting the device
2.3 Noting the identification information
Number
2-3
Advertisement
Table of Contents
