Headlight Adjustment; Front Direction Indicators; Rear Optical Unit - PIAGGIO Beverly 125 Maintenance Manual

Headlight adjustment (03_24)

Proceed as follows:
1. Position the unloaded scooter, in running order and with the tyres inflated to the
prescribed pressure, onto a flat surface 10 m away from a half-lit white screen; ensure
the axis of the scooter is perpendicular to the screen;
2. Turn on the headlight and check that the limit of the projected light beam is not over
9/10 or below 7/10 of the distance from the ground to the centre of the headlight;
3. If this is not the case, regulate the headlight by turning screw "A".
03_24
N.B.
THE ABOVE PROCEDURE COMPLIES WITH THE EUROPEAN STANDARDS RE-
GARDING MAXIMUM AND MINIMUM HEIGHT OF LIGHT BEAMS. REFER TO THE
STATUTORY REGULATIONS IN FORCE IN EVERY COUNTRY WHERE THE ve-
hicle IS USED.

Front direction indicators

To replace a burnt out bulb remove the right and left screw «F».

Rear optical unit (03_25, 03_26, 03_27)

To remove the rear light assembly, proceed as follows:
1. Remove the two side mouldings.
2. Remove the plastic cover of the luggage rack and remove the screw «C».
3. Remove screws "B" and pull out the rear light assembly.
4. If necessary, replace the blown bulb.
03_25
60