Table of Contents
Advertisement
The 'battery status' indicator:
1/3, minimum). When your RC9800i is docked and charging, the battery status
indicator is animated.
The 'Time' indicator: The time is indicated in HH.MM or HH.MM PM/AM format.
To change the time or time format, see page 43.
The 'IR active' indicator:
are being sent. In the event that the RC9800i has no remote control code available
for the button pressed, the IR indicator will turn red and the RC9800i will beep. You
can find out which codes are missing. See 'Changing the remote control codes of a
device' on page 45.
The 'Network' indicator:
strength. In the event of the network strength becoming low, a single red bar will
be displayed.
Watching Satellite TV
To watch satellite TV, perform steps 1 to 3 as described in 'Watching Cable TV' on
page 29. Instead of selecting the cable box as the applicable source, select the satellite
receiver
Watching Broadcast TV
To watch broadcast TV (i.e. use the TV's internal tuner), perform steps 1 - 3 as
described in 'Watching Cable TV' on page 29. Instead of selecting the cable box as the
applicable source, select the TV's internal tuner
Watching DVD
You're going to watch a DVD movie on your TV in the living room.
To do so proceed as follows:
1 On the Homepage of your RC9800i,
choose Watch.
2 Select the DVD
source.
The combined control screen TV-DVD
will appear.
The RC9800i will take care of switching your
TV to the DVD input.
3 In the combined control screen for
TV-DVD, choose the desired function.
Watching PVR
To watch PVR, perform steps 1 and 2 as described in 'Watching DVD'. Instead of
selecting the DVD as the applicable source, select the PVR
control screen for TV-PVR, choose the desired function.
User Manual
31
. This indicator lights up when remote control codes
. The number of bars is an indication of the network
.
as the applicable
Getting the Most Out of It
. This indicator goes through 4 stages (full, 2/3,
.
. In the combined
Advertisement
Table of Contents
