NorthStar SiteStar Series Maintenance Instructions Manual page 33

Reinstalling EQ Zone 4 Components
This section is only valid for EQ Zone 4 Cabinets.
Do the following to reinstall the corner pieces, the front bars and the cross
braces:
If removed, reinstall the corner pieces to the EQ Zone 4 structure as in
Figure 24.
Tighten the four M6 screws at each corner to a torque of 9 Nm.
Figure 24 Reinstalling Corner Pieces
Fit the front bars to the EQ Zone 4 structure as in Figure 25.
Note: Use the inner front bar position for the 100 Ah batteries.
Use the outer front bar position for the 170/180 Ah batteries.
Tighten the six M6 screws at each front bar to a torque of 9 Nm.
Doc. No: D000100-INS-03, Rev D Page 33 of 36