Cleaning Of The Climate Unit - NorthStar SiteStar Series Maintenance Instructions Manual

Figure 2
Figure 3
6.3 C
LEANING OF THE
If the condenser is fully clogged with dirt at the first 24 months service, the
service intervals must be narrowed down, to remain a long term reliable
system.
Do the following to clean the climate unit:
1. Remove the swing handle by removing the Torx screw as in the
Doc. No: D000100-INS-03, Rev D
Earth Ground Connection at Cabinet without EQ Zone 4
Reinforcement
Earth Ground Studs in EQ Zone 4 Cabinet
C
figure below. Use a T30 screwdriver with a minimum blade length of
75 mm.
U
LIMATE NIT
Page 14 of 36