Advertisement
INSTALL THE FREESTANDING BATH
INSTALL THE FREESTANDING BATH
1. Make sure the floor is as flat as possible when
choosing the position for installing the bathtub
(uneven floor or tiles could affect the overall
installation). Place the cast iron bathtub at a tilt or
place the bottom on top (at least 2-3 people required;
please be careful) and following instructions in the
following figure to adjust the supports. Adjust the
screws so that the bottom of the edges of the bath
tub is 573mm from the floor and the bottom of the
bathtub is 105mm from the floor. Use the same
method to install other adjustable supports. (The
height adjustment is for facilitating follow-on
installation of the wood base and it is suitable for flat
surfaces.)
105
2. After the supports are adjusted, return the cast iron
bathtub to its normal position with the bottom facing
down as illustrated in the following figure. Shake the
cast iron bathtub to verify whether the four supports
are even. If the bathtub is shakable, it means that the
floor is not sufficiently even. You can use a wrench to
adjust 1 screw with the highest deviation so that the
four supports are placed on the floor.
Install and tighten the bathtub water drain and pull
out the drainage pipe.
1315528-T01-B
1.
M8
M12
573
2.
-3-
573mm
105mm
Bath
Go Down
Adjustable Feet
Tighten
Tighten
1
2-3
Go Up
Advertisement
