Table of Contents
Advertisement
Troubleshooting
⚠
WARNING
Issue
Platform does not raise.
Platform lowering on its own.
Lift is making odd noises as it raises
and lowers.
Lift wobbles as it raises or lowers.
Lift becomes inoperative with
vehicle raised on the Lift.
RML-1500XL ATV / Motorcycle Lift
Disconnect the Lift from its pressurized Air Supply (if connected) before
performing any troubleshooting procedures. The Lift uses pneumatic (air)
energy; if your organization has Lockout/Tagout policies, make sure to
implement them once the Lift is connected to a pressurized Air Supply.
Action to Take
Make sure you have a pressurized Air Supply attached or are
using the Raising Pedal.
Make sure the Hydraulic Hose is connected to the bottom of
the Hydraulic Cylinder and to the Pump.
Make sure the Lift has less than 1500 pounds / 680 kg on it.
Do not overload the Lift.
Make sure the Safety Lock Plate is engaged on a Safety Lock.
Make sure the Lift is not overloaded.
Lubricate hinge points using white lithium grease.
Make sure the vehicle on the Lift is correctly secured.
If Platform is engaged on a Safety Lock, the Platform will
stay raised. To lower it, use another lifting device to raise
the vehicle off the Platform a few inches, raise the Platform
to get it off its Safety Lock, put the vehicle back onto the
Platform, then lower the Platform to the ground. Once the
vehicle is safely off the Platform, take the Lift out of service,
determine the source of the problem, resolve the problem
yourself, or visit www.bendpak.com/support/, email
support@bendpak.com, or call BendPak Ranger at (805)
933-9970. Do not put the Lift back into service until the
issue has been resolved.
23
P/N 5900183 — Rev. E — Feb. 2020
Advertisement
Table of Contents
