Page 1
1645 Lemonwood Dr. Santa Paula, CA 93060 USA Toll Free: 1 (800) 253-2363 Tel: 1 (805) 933-9970 rangerproducts.com Ranger Floor Jack Installation and Operation Manual Manual Revision B — July 2017 — Manual P/N 5900393 Model: • RFJ-3TQP ⚠ Read the entire contents of this manual before using this product.
Page 2
Warranty. The BendPak Ranger warranty is more than a commitment to you: it is also a commitment to the value of your new product. For full warranty details and to register your new BendPak Ranger product, contact your nearest BendPak Ranger dealer or visit www.bendpak.com/support/warranty.
Components Parts Breakdown Introduction This manual describes the RFJ-3TQP Ranger Floor Jack, which quickly and easily raises vehicles. More information about the full line of Ranger Products is available at rangerproducts.com. This manual is mandatory reading for all users of the RFJ-3TQP, including anyone who sets up, operates, maintains, or repairs it.
BendPak Ranger assumes no liability for damages resulting from: • Use of the product for purposes other than those described in this manual. • Modifications to the product without prior, written permission from BendPak Ranger. • Damage to the product from external influences. •...
Lifting Arm: Moves the vehicle up and down. • Wheels and Casters: Let you easily move the Jack. • Hydraulic System: Provides power to the Jack; comes fully functional. Ranger Floor Jack P/N 5900393 — July 2017 — Rev. B...
Go slightly higher than the height of the jack stands you plan to use to support the vehicle. Refer to bendpak.com/shop-equipment/jack-stands/ for more information about jack stands that are available from BendPak Ranger. 7. Place the jack stands under the vehicle at locations recommended by the vehicle manufacturer. ⚠ WARNING Do not get under the vehicle without it being supported by jack stands.
The hydraulic fluid should be level with the bottom of fill hole. If not, top it off . Do not overfill. Only add new, clean hydraulic fluid. 4. Replace the fluid fill plug. Ranger Floor Jack P/N 5900393 — July 2017 — Rev. B...
Purge air from the Hydraulic System. Check hydraulic fluid level; top off if low. Jack feels “spongy” when lifting. Purge air from the Hydraulic System. If you continue to have problems with your Jack, call Ranger Products at (805) 933-9970 or visit www.bendpak.com/support/. Parts Breakdown Ranger Floor Jack...
Page 9
Connecting Rod, Pump Unit Flat Washer 6 Oil plug M6 Spring Washer 18 Lifting Arm Linking Bolt, Handle Socket Saddle Spacing Collar, Handle Socket Bolt, Connecting Rod Side Plate Ranger Floor Jack P/N 5900393 — July 2017 — Rev. B...
Page 10
Ranger Floor Jack P/N 5900393 — July 2017 — Rev. B...
Page 11
Steel Ball Valve Base 33-21 Adjusting Pressure Screw 33-45 O-Ring, Safety Valve 33-22 Copper Washer 33-46 Screw, Safety Valve 33-23 Pump Body 33-47 Lower Retainer Ring 33-24 Y Type Washer, Piston Plunger Ranger Floor Jack P/N 5900393 — July 2017 — Rev. B...