Transmitter Battery Installation - Fisher-Price Radio-Control Raceway Instructions Manual

Table of Contents

Advertisement

Transmitter Battery Installation

Antenna
• Unfasten the screw in the battery compartment door with a
Phillips screwdriver. The screw will remain in the door.
• Lift the battery compartment door open.
• Insert a new 9-volt alkaline battery into the battery
compartment, terminal end first, as indicated on the battery
compartment door.
• Close the battery compartment door and tighten the screw
with a Phillips screwdriver. Do not over-tighten.
Please Note: If the battery compartment door will not close,
check the battery orientation. Make sure the battery terminals
are toward the antenna.
• Repeat this procedure to install the battery in the other
transmitter.
+
Battery
Compartment
Door
Use
The radio control cars operate on separate radio
frequencies. The red transmitter controls the red car; the
blue transmitter controls the blue car.
Important Note: Be sure to use the cars only on the track.
They are not designed to be used any other way.
On/Off
Switch
• Turn the car upside down.
• Slide the switch on the bottom of the car to the
"ON" (
) position.
Start
Button
• Turn the car upright.
• Press the start button on the top of the car. (The L.E.D. will
light and the tires will jump forward a little.)
• Select a speed by sliding the speed control switch to:
- Fast
- Slow
Please Note: If the speed control switch does not move
easily, rotate the rear wheels slightly with your hand and slide
the speed control switch at the same time.
5
Bottom View
L.E.D.
Speed
Control
Switch
Top View

Advertisement

Table of Contents
loading

Table of Contents