Switch On The Phone; Charge The Battery - Philips CTS800/000APMEA User Manual

Mobile phone
Hide thumbs Also See for CTS800/000APMEA:
Table of Contents

Advertisement

S800_EN.book Page 5 Friday, February 10, 2006 6:46 PM

Switch on the phone

To switch on the phone, long press ) key. Enter
the PIN code if required. The PIN code is a 4- to 8-
digit secret code of your SIM card. It is preconfigured
and communicated to you by your operator or
retailer. For more information on PIN codes, see
"Security Setup".
If you enter an incorrect PIN code three times in
succession, your SIM card will be locked. To unlock it,
you must obtain the PUK code from your network
operator.

Charge the battery

Your phone is powered by a rechargeable battery. A
new battery is partially charged and the phone will
emit an audible alert to warn you when the battery
level reaches low.
Charging with the travel charger
Plug the charger into the charger connector at the
bottom of the phone and ensure that the arrow
symbol on the charger is facing upwards as shown
below. Then plug the other end of the charger into an
AC power socket.
The battery symbol indicates the state of charge. The
charge indicators will scroll when the battery is
Getting Started
charging. The battery is fully charged when the charge
indicators stop scrolling. You can then disconnect the
charger.
Keeping the charger plugged to the mobile phone
when the battery is fully charged will not damage the
battery. The only way to disconnect the charger is to
unplug it, so use an easily accessible AC power socket.
If you are not using your phone for a period of time,
we recommend that you remove the battery.
You can use your phone while it is charging. When the
battery is completely discharged, the charge indicators
will appear only after a few minutes of charging.
5

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cts800/bs1ua0hcS800

Table of Contents