Figure 3-11 Ground cable lugs (single and double)
Figure 3-12 Ground strip
Procedure: Install an ONS 15252 MCU Single-Lug Ground Connection
Remove one M6 nut and washer from one of the grounding pins located on either side of the MCU
Step 1
backplane.
Route the ground cable to the grounding pin where the M6 nut and washer were removed.
Step 2
Attach the ground cable to the grounding pin using the M6 nut and washer removed in
Step 3
Use a socket wrench to firmly tighten the M6 nut on the grounding pin. The attached ground cable should
Step 4
look similar to the one shown in
Cisco ONS 15200 Installation, Setup, and Test Manual
3-14
Figure
3-13.
Chapter 3
Installation
Step
1.
78-13765-01