Pioneer DMH-ZF9350BT Quick Start Manual page 19

Double-sided tape
Clamps
Use separately sold clamps to secure
the lead where necessary inside the
vehicle.
NOTE
Install the microphone on the steering
column, keeping it away from the steering
wheel.
Adjusting the microphone angle
The microphone angle can be adjusted.
The adjusting position
and mounting
dimension of the
display
▶DMH-ZF9350BT
The mounting position of this unit's display
can be adjusted (front-back/up-down/
right-left/angle). When mounting the
display, adjust the mounting position and
dimensions so that your view is clear and it
does not impair your driving.
WARNING
Make sure that none of the following
conditions exist when mounting the
display. Otherwise, an accident may occur.
• It impairs the operation of the steering
wheel and levers (gearstick, windscreen
wiper switch, turn signal switch, etc.).
• It impairs the operation of the airbags.
• It significantly impairs the operation of
the hazard switch.
• It impairs the ability to identify or operate
other control switches.
• You are unable to see gauges, metres or
warning indicators.
• It interferes with in-vehicle devices
(switches, panel, glove box, cup holder,
etc.).
Depending on the vehicle, the display may
hinder access to the glove box or cup
holder, or it may block the air conditioner
vents.
Display mounting dimensions
and adjustable positions
▶Front-back position
Front
75
38.1
mm
Back
55
18.1
mm
▶Left-right position
Centre
115.4 115.4
mm
Left
145.4 85.4
mm
Right
85.4 145.4
mm
En
17