Alarm Recording; Connecting An Alarm Sensor; Setting The Alarm Speed And Duration - Sony SVT-DL224 Operating Instructions Manual

Alarm Recording

You can use a door switch or alarm sensor to trigger
alarm recording. You can make alarm recording in
recording mode, stop mode and power off mode with
the selected recording speed.

Connecting an Alarm Sensor

Commercially available
switching box, etc.
to COM to ALARM OUT
to ALARM IN
to COM
Setting the Alarm Speed and
Duration
1
1
Press MENU until the SET UP display appears on
the screen.
< >
SET UP
REC TAPE END
ALARM DURATION
ALARM SPEED
TAPE IN
OVERWRITE INHIB.
REMOTE
WARNING OUT
CLOG DETECT
2
Press SHIFT v to move the flashing to ALARM
DURATION.
3
Set ALARM DURATION to 20S, 40S, 1M, 2M,
3M, 5M, CC or TRIGG.
20S/40S - 5M: for recording for 20 seconds, 40
seconds, 1 minute, 2 minutes, 3 minutes or 5
minutes
CC: for recording as long as the alarm signal is
being input
TRIGG: for recording from the alarm signal to the
next alarm signal.
4
Press SHIFT v to move the flashing to ALARM
SPEED.
5
Set ALARM SPEED to 8H or NC by pressing
DATA '/'.
8H: for recording in 8-hour mode
NC: for recording at the same speed as before the
alarm was received.
6
Press PAUSE to return to the normal display.
2-5 6
REW
20S
8H
STOP
N
MODE1
MODE1
Y
21