Sony TRINITRON BVM-8045QD Operation Manual page 28

Location and Function of Parts and Controls
wa V HOLD (vertical hold) control
Turn to stabilize the picture if it rolls vertically.
After the picture is stabilized, display another signals
and adjust this again so that the picture is stabilized
even when another signal is selected.
ws DC 12V IN jack (XLR, 4 pin)
Connect the DC 12 V power source to operate this
monitor.
wd COMPONENT LEVEL selector
Select the component level from among two modes.
N10/SMPTE: for 100/0/100/0 signal
BETA 0 : for 100/0/75/0 signal
wf RGB/Y R-Y B-Y selector
RGB: Set to this position to input the analog RGB
signal.
Y R-Y B-Y: Set to this position to input the
component signal.
wg RGB/COMPONENT input connectors (BNC)
To monitor a signal fed through these connectors,
depress the LINE/RGB input selector on the front
panel (RGB) and the A/B, SDI/RGB input button
(RGB). When the SYNC INT/EXT selector on the
front panel is released (INT), the monitor operates on
the sync signal from the G/Y channel.
• To monitor the analog RGB signal
Connect to the analog RGB signal outputs of a
video camera. Depress the A/B, SDI/RGB input
selector on the front panel (RGB).
Set the RGB/Y R-Y B-Y selector wf on the rear
panel to RGB.
Relationships between the selectors, connectors and the input signal
The input signal is changed by the selectors and connectors on the front and rear panels as listed below.
Selectors and
connectors
Input signal
A
COMPOSITE
B
Y/C
COMPONENT SDI
ANALOG RGB
COMPONENT
(Y R-Y B-Y)
6
(GB)
Front panel
A/B, SDI/RGB input LINE/RGB input
selector qa selector 0
A 4 LINE
B $ LINE
A 4 LINE
SDI 4 RGB
RGB $ RGB
RGB $ RGB
• To monitor the component signal
Connect to the Y/R-Y/B-Y component signal
outputs of a Sony BetaCam video camera. Depress
the A/B, SDI/RGB input selector on the front
panel (Y R-Y B-Y). Set the RGB/Y R-Y B-Y
selector wf on the rear panel to Y R-Y B-Y.
wh AC IN socket
Connect the supplied AC power cord to this socket.
wj COMPONENT SDI IN/OUT connectors (BNC)
Depress the LINE/RGB input button (RGB) and
release the A/B SDI/RGB input button (SDI) on the
front panel.
IN: Inputs SMPTE 259M/CCIR 656-III 4:2:2 serial
digital signals from Digital BETACAM VTRs,
etc.
OUT: Outputs the digital signal of the equipment
connected to the COMPONENT SDI IN
connector (Active through).
We recommend to connect the following cable to
this connectors.
Coaxial cable: 5C-2V (Max. 200 m, 656 feet)
Fujikura America Inc., Fujikura
Europe Ltd (FEL) or the equivalent
Input connector
4 LINE A (VIDEO)
4 LINE B
4 LINE A (Y/C)
$ COMPONENT SDI
$ RGB/COMPONENT
$ RGB/COMPONENT
Rear panel
RGB/Y R-Y B-Y
selector wf
—
—
—
—
RGB
Y
R-Y
B-Y