Table of Contents
Advertisement
Building Technologies
Fire Safety & Security Products
Set user functions to factory default settings
The user functions of all programming steps can be set to factory default values
with one operation.
1. Disconnect mains and battery
2. Press and hold numeric keys (7) 1, 2, 3, 4 simultaneously followed by reconnect-
ing mains
LED block (1) starts flashing
–
3. Release numeric keys (7)
4. Press numeric keys (7) 1, 2, 3, 4 simultaneously again
LED block (1) stops flashing and double beep of buzzer occurs
–
System is now set to default
–
5. Reconnect battery
Note:
For factory default settings
see under Log sheet for programmed user functions
Configuration
31
A6V10265083_a_en_--
03.2010
Advertisement
Table of Contents
