Installing Central Wheels (24" Or 22") - Invacare Action3 NG RC Service Manual

WARNING
Make sure the detent pin and locking pins of the quick-release axle are fully released before
operating the wheelchair.
The locking pins MUST be protruding past the inside of central wheel hub for a positive
lock.
Keep locking pins clean.
Invacare recommends inserting quick-release axles with the head end to the inside of the
wheelchair to prevent accidental release during contact leisure activities.
2.1.2

Installing Central Wheels (24" or 22")

NOTE: For this procedure, refer to FIGURE 2.1.
1. Install the existing quick release axle through the new/existing central wheel.
2. Install the new/existing central wheel and quick release axle into the axle bracket (B) on
the wheelchair frame. Refer to section 2.2 Adjusting Quick-Release Axles if the locking
pins are not protruding past the inside of the axle bushing or there is too much
movement of the central wheel assembly in a back and forth position.
NOTE: The front castor needs to be adjusted at the same position in accordance with the central
wheel size (24" or 22").
Refer to sections Adjusting Castor Angle and Adjusting Castor Assembly Position and Changing Seat-
to-floor Height table, in the ordinary Action3 NG Service Manual.
60122664-A 7