Table of Contents
Advertisement
Available languages
Available languages
deflating as small particles could become airborne with the release
of the air pressure.
Always lock the valve cover over the valve stem when in use. This
will prevent accidental air release and entrance of any particles into
the air chambers.
3. ISUP Board inflation Steps
f.
Unscrew the valve cap, press down the valve
pin to open the valve, Let the air flow naturally
into the product, In order to save the time of
inflation, then press down the valve pin again
to close the valve (in "UP" position).
g. Make sure the pump hose is connected to the
"inflate" outlet.
h. Connect the pump nozzle into the valve
receptacle, with a half twist motion (clockwise)
i.
Start pumping air into the board by sliding the
pump piston up and down. At the beginning,
you can close the switch tap for double action,
and then open the switch tap for single action.
Inflate until you reach the required pressure.
Minimum 12psi for proper ISUP operation and maximum of
EN
Advertisement
Table of Contents
