Safety Precautions - Gaggia W2IXX014MENXXC User Manual

IMPORTANT
- Do not connect any domestic appliance with rated power above 130 W to the power socket
located on the appliance (E).
- Do not vacuum any foamy liquids. If foam or water flows out from the rear blowing socket (H),
stop the appliance immediately and wait for the appliance and accessories to dry before resuming
normal operation.
- Should you need to replace any control or safety devices, make sure you only use original parts.
SERVICING OF THE INNER PARTS OF THE APPLIANCE SHOULD ONLY BE CARRIED
OUT BY AUTHORISED GAGGIA SERVICE CENTRES

SAFETY PRECAUTIONS

- Place the appliance in its horizontal position. When operating the appliance, never leave the
machine in its upright position.
- The appliance must not be used by children. It should only be operated by adults who have
learned beforehand how to use the appliance.
Our appliances have been manufactured in full compliance with the applicable standards
and regulations in force.
PREPARING THE APPLIANCE READY FOR USE
Before using the appliance, make sure that
the recovery tank (G) is correctly fastened to
the upper housing with the catches provided
(F).
- Fill the recovery tank (G) with 2.5 litres of water.
This operation should be carried out after the top
part of the machine has been removed by opening
the catches provided (F).
NOTE
A few drops of scented (non-foamy) liquid
may be poured into the tank to freshen the
air to be blown into the room.
IMPORTANT
- Reposition the top part of the machine onto
the recovery tank in the direction indicated
(Fig. 3).
- Fasten the catches (F) and ensure that the top and
bottom parts fit properly.
NOTE
Fig. 3
18
IMPORTANTE
Vertiendo en el depósito de recuperación (G) 2,5
litros de agua limpia, el aire es filtrada y las impurezas
(polvo, gérmenes, etc.) retenidos en el depósito (G)
(Fig. 4). Durante la utilización asegurarse siempre
de no superar el nivel máximo para evitar salidas
de chorros de agua por el silenciador.
ENGANCHE DEL TUBO FLEXIBLE PARA LA
FUNCIÓN DE ASPIRACIÓN (Fig. 5-6)
- Introducir la unión (1) del tubo flexible (2) en la sede de
la toma accesorios (D).
ENGANCHE DEL TUBO FLEXIBLE PARA LA
FUNCIÓN DE SOPLADO
- Se puede introducir la unión (1) como indicado arriba en
las figuras 5 o 6 también en la toma posterior de soplado
(H) tras remover el silenciador (I).
FUNCIONAMIENTO
- Conectar el enchufe de alimentación eléctrica en la toma
de corriente.
- Apretar el interruptor general luminoso (B).
- Para regular la aspiración actuar sobre el mando (C),
girarla en el sentido inverso al de las agujas del reloj para
una mayor aspiración y en el sentido de las agujas del reloj
para una menor aspiración. (Fig. 7)
Fig. 7
Entrada aire
Salida
Aire
puro
Filtración aire
Fig. 4
Fig. 5
1
C
2
Fig. 6
55