Table of Contents
Advertisement
White Balance
This setting determines the maximum output values for each color, which affects the appearance of a full
output white.
1.
Go to the White Balance main level.
2.
Select Off (the product will use a default setting) or Manual.
3.
For Manual mode, select the color value to edit (Red, Orange, Green, Royal Blue, Blue, or
Lime Green).
4.
Set the maximum value for the selected color (125–255).
5.
Repeat steps 3 and 4 until the product outputs as desired.
LED Frequency
This option changes the Pulse Width Modulation (PWM) frequency of the LEDs on the
Ovation F-415VW. To do so, follow the instructions below:
1.
Go to the LED Frequency main level.
2.
Select PWM Frequency (600Hz, 1200Hz, 2000Hz, 4000Hz, 6000Hz, or 25Khz).
Fan Mode
This setting determines how the fan speed on the Ovation F-415VW is set.
1.
Go to the Fan Mode main level
2.
Select Auto (fan speed will increase or decrease based on product temperature), Off (fan will
stay off. Product output will decrease based on product temperature), Silent (fan will maintain a
constant silent speed), or On (fan speed will always be at maximum).
NOTICE: When operating in Fan Mode: Off, the output of the fixture will be reduced
and will not reach the same levels as when using other fan modes.
WARNING: When operating in Fan Mode: Off, the fixture will become hotter to the
touch than when using other fan modes. Use proper protective equipment to prevent
burns. Keep a safe distance from flammable objects.
Back Light
This setting allows for selection of the amount of time the backlight on the Ovation F-415VW's display
stays on after the last button is pressed on the control panel.
1.
Go to the Back Light main level.
2.
Select 10S (10 seconds), 30S (20 seconds), 2Min (2 minutes), or Always On (remains on).
System Information
This option displays the total number of hours the product has run, the installed software version, and the
product's UID.
1.
Go to the Information main level.
2.
Select Fixture Hours, Version, or UID.
Zoom Reset
This setting determines whether the zoom resets when power is applied to the Ovation F-415VW.
1.
Go to the Reset Zoom w/ Power main level.
2.
Select No (zoom stays in last command position when product is turned off) or Yes (zoom resets
when product is turned on).
Factory Reset
This option restores the Ovation F-415VW to factory default settings.
1.
Go to the Reset Factory main level.
2.
Select No or Yes.
Page 12 of 20
O
Ovation F-415VW User Manual Rev. 4
PERATION
Advertisement
Table of Contents
