Table of Contents
Advertisement
ASSEMBLY
1. Insert Feed Screw into Cutter
Housing. (Ill. 1)
2. Place the Cutter Knife on Feed
Screw shaft, with cutting edges
toward the outside. (Ill. 1)
3. Place the selected Cutter Disc on
shaft. Be sure notch in the Cutter
Disc fits around pin in Cutter
Housing opening. (Ill. 2)
4. Screw on Ring Collar until tight
against cutters. If it binds, back up
and start again until Collar screws
on easily. (Ill. 3) NOTE: when
properly assembled, shaft will
protrude from Cutter Disc. If not
tightened securely, unit will not grind
properly.
5. Slide Food Tray snugly onto Cutter
Housing. Do not operate without
Food Tray in place. (Ill. 4)
GRINDING INSTRUCTIONS
1. Place Cutter Housing on Power Unit by
inserting at a slight angle to the right and
rotate it to the left until it clicks in upright
position. (Ill.5)
2. Position the unit on counter and plug into a
110 Volt AC outlet.
3. Place a shallow wide bowl under the Cutter
Housing to catch food.
4. Prepare food in advance by cutting into strips
or cubes slightly smaller than the opening in
the Food Tray.
5. Switch Power Unit "On" before adding food.
6. Feed food into Cutter Housing slowly and evenly. Most food will feed into the
Grinder without force. If pressure is required, use Food Pusher. Push gently
- do not force.
Advertisement
Table of Contents
