ResMed Astral Mobility bag User Manual page 7

Setting up the SlimFit mobility bag
Refer to illustration F
1. Place bag on a flat surface and slide the Astral device into the
Slimfit mobility bag ensuring the handle is accessible.
2. Once in place, fasten the flaps under the handle of the Astral
device and secure in place using the VELCRO
3. Attach required straps to use as a backpack, carry bag or
wheelchair attachment.
Connecting oxygen and other accessories
WARNING
When using supplemental oxygen inside the mobility bag,
the maximum permitted flow rate is 6 L/min. Oxygen can be
used with a double limb circuit in a SlimFit mobility bag.
Refer to illustration G
Oxygen and other accessories can be connected to the Astral
device through the cable ports on the rear access panel of the
mobility bag.
• Connect oxygen to the low flow oxygen inlet at the rear of
the device. For full instructions on using oxygen with the
Astral device, refer to the Astral Clinical Guide.
• When using a pulse oximeter with the device, ResMed
recommends placing the cables around the side of the
device through the circuit flaps on the front panel.
For a full list of accessories, see the Ventilation accessories
guide on www.resmed.com. If you do not have internet access,
please contact your ResMed representative.
For use with a wheelchair
Refer to illustration H
1. Attach the four wheelchair straps to the attachment points on
the sides of the mobility bag.
2. Attach each of the four straps around a secure part of the
wheelchair, tighten or loosen as required.
Note: Alternatively, secure the bag using the backpack or
shoulder straps.
For use as a backpack
Attach the backpack straps using the VELCRO
secure to the attachment points at the top and bottom of the
mobility bag.
For use over the shoulder
For the mobility bag, secure the shoulder strap to the top two
attachment points of the mobility bag.
For the SlimFit mobility bag, adjust the length of one backpack
strap to use as a shoulder strap.
strip.
®
strips and
®
English 3