Scan; Turning Scan On Or Off - Motorola WAVE TLK 100 User Manual

3 On the device "friendly" name, press and hold the
Menu/Programmable button to clear the pairing.
If clearing the bluetooth pairing successfully, a positive tone
sounds.
If clearing an unpaired device, a negative tone sounds.

Scan

This feature allows your radio to cycle through the
programmed scan list for the current channel looking for
voice activity.
When in the scan mode, the system preempts an ongoing
low-priority talkgroup call. Your radio unmutes to the high-
priority talkgroup call. You respond to the active talkgroup
when you press the PTT button during the programmed
period (hang time) of an ongoing call from your scan list.
Pressing the PTT button when the radio is not in a call,
causes the radio to start a call on the last selected
talkgroup.
NOTICE:
If the DND mode is enabled during the scan mode,
your radio prioritizes the DND mode.

Turning Scan On or Off

NOTICE:
Depending on the configuration of your radio, press
or press and hold the Menu/Programmable button
to directly access the feature. Else, manually enter
the feature with the following procedure.
1 Press the Menu/Programmable button.
2 Locate the Scan icon.
3 To turn on Scan, press the Volume Up button. To
turn off, press the Volume Down button.
If Scan is on, the following occurs:
• Voice Announcement sounds Scan On.
• The display shows a check mark beside the Scan icon.
• The amber LED blinks.
If Scan is off, the following occurs:
• Voice Announcement sounds Scan Off.
• The display shows an "X" mark beside the Scan icon.
English
41