Intenza" Water Filter - Philips HD8838/04 Operating Instructions Manual

"INTENZA" WATER FILTER

To improve the quality of the used water,
it is advisable to install the water fi lter.
Remove the water fi lter from its packag-
ing, immerse it vertically (with the open-
ing positioned upwards) in cold water
and delicately press the sides so as to let
the air bubbles out.
Remove the small white filter from the
tank and store it in a dry place sheltered
from dust.
Set the Intenza Aroma System as specifi ed
on the box.
A = Soft water
B = Hard water (standard)
C = Very hard water
Insert the fi lter into the empty tank. Press
it until its limit stop.
Fill the tank with fresh drinking water and
reinsert it into the machine.
Dispense the water in the tank by using
the hot water function (see section "Hot
water dispensing").
Fill the water tank again.
Turn the selector switch counter-clock-
wise and set it to the "
Condition for fi rst use of the machine.
• 8 • • 8 •
Orange
Orange
Orange
Orange
" position.
Press the " " button until the following
page is displayed.
Press the " " button to select "ON" and
press the " " button to confi rm.
In this way, the machine has been pro-
grammed to inform the user of the need
to replace the fi lter.
Note: When an "Intenza" fi lter
must be replaced with a new
one, the function must be reset. Re-
place the fi lter as previously shown.
After that, enter the programming
menu until the indicated window
is displayed and select the "RESET"
option. Then press the " " button.
This way, the machine is programmed
to manage a new fi lter.
Note: If the fi lter is already
installed and you want to
remove - but not replace - it, select
the "OFF" option and then press the
" " button.
To exit, turn the selector switch clockwise
and set it to the " " position.
Note: If there is no Intenza
water fi lter, insert the previ-
ously-removed small white fi lter into
the water tank.