Broan DESIGNER Series Instructions Manual page 2

::
.com
bathroomsource
INSTALL THE HOUSING
New Construction
1. Slide adjustable mounting
brackets into channels on
sides of housing.
2. Choose the location for
your fan/light in the ceiling.
For best possible perfor-
mance, use the shortest
possible duct run and a
minimum number of el-
bows.
3. Position mounting brackets against joist. Mark the keyhole
slot on both mounting brackets.
4. Set housing aside and drive nails partially into joist at the
top of both keyhole marks.
5. Hang housing from nails and pound nails tight. To ensure
a noise-free mount, crimp the bracket channels tightly
around the mounting brackets.
Broan at
Call 1-800-667-8721 anywhere in the US and Canada -
®
Position bottom
edge of brackets
slightly above
bottom edge
of joists.
::bathroomsource.com
MODELS 710 • 714 • 721 • 722
INSTALL THE HOUSING
(continued)
New Construction
ADJUSTMENT SCREWS
6. To adjust vertical housing position: Loosen adjustment
screws on both sides of housing. Move housing up or down
until adjustment screws line up with mark indicating your
finished ceiling thickness. Tighten screws securely.
Existing Construction
1. Choose the location for your fan/light in the ceiling. For
best possible performance, use the shortest possible duct
run and a minimum number of elbows.
2. In attic, position housing in
desired location. Trace outline
of housing on ceiling material.
Position bottom
edge of brackets
slightly above
bottom edge
of joists.
4. Place housing in opening. Position mounting brackets
against joist and nail to joist through keyhole on both sides.
To ensure a noise-free mount, crimp the bracket channels
tightly around the mounting brackets.
kitchen::
is a division of
U N L
www.bathroomsource.com
Page 2
1-1/4 1-1/4
1 1
3/4 3/4
1/2 1/2
3. Set housing aside
and cut ceiling open-
ing slightly larger
than marked.
accessories
I M I T E D