1
: Pull throttle rod (1) out through
the grommet (2) in direction of
carburetor.
– Inspect throttle rod and grommet,
replace if necessary.
– Inspect the retainer and replace if
necessary, b 7.12
Installing
1
2
3
: Use STIHL press fluid to ease
installation – do not lubricate
grommet (2) with grease, b 16
: If necessary, install the
grommet (2) and push throttle
rod (1) into the grommet (2) so
that the end with the hook (arrow)
faces the carburetor, then
position retainer (3) against
guides (arrows).
92
Models without M-Tronic
1 2
2
: Short circuit wire (1) must be
seated in the guide (2) – loop
(arrow) allows for movement.
Models with M-Tronic
1
4
2
5
: Ground wire (1), short circuit
wire (2) and M-Tronic wire (3)
must be seated in the guides (4,
5, 6), push them into the guides if
necessary – loops (arrows) allow
for movement.
MS 661, MS 661 C-M
6
3
6