Stihl Autocut 2-2 Mowing Head; Mounting The Loop Handle - Stihl FSA 56 Instruction Manual

7 Assembling the Trimmer
1
2
The line limiting blade (1) is already installed in the deflector
(2) and must not be removed.
► Push the deflector (2) into the guides on the housing as far
as stop.
The deflector (2) is tight against the housing.
► Insert and tighten down the screws (3) firmly.
The deflector (2) must not be removed again.
7.2

STIHL AutoCut 2-2 Mowing Head

7.2.1 Installing the Spool
► Switch off the trimmer and remove the battery.
► Place spools in a container filled with water for 12 to 24
hours before installing.
This makes the nylon mowing lines supple.
1
2
3
► Thread the ends of the nylon lines (4) from the spool (2)
through the openings (1) in the mowing head (5).
0458-713-9821-D
3
2
4
5
6
7
► Insert the spool (2) in the mowing head (5).
► Fit the cover (7) on the mowing head (5) so that its tabs
(3) line up with the openings (6) in the mowing head (4).
► Push the cover (7) onto the mowing head (5) as far as
stop.
The tabs (3) engage audibly.
7.2.2 Removing the Spool
► Switch off the trimmer and remove the battery.
1 1
► Press in the tabs (1) and remove the cover (3).
► Remove the spool (2).
7.3

Mounting the Loop Handle

► Switch off the trimmer and remove the battery.
2
1
► Line up the loop handle (2) so that the recess for the star
knob nut (1) is on the right of the control handle and the
openings in the loop handle (2) are facing the operator.
English
2
3
3
45