Replacing the Front Doors and Frame Assembly on the Cisco Nexus 7010 Chassis
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
1
Bottom frame assembly with screw holes
aligned to screw holes in chassis.
For each of the two front doors, match the two alignment pins on the door frame to the alignment holes
Step 2
on the chassis. Position each door frame immediately under the cable management area (see
Figure
Figure 9-21
1
Front door frames.
2
Cable management area.
Tighten three captive screws for each door frame (see
Step 3
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
9-48
9-21).
Installing the Front Doors
Chapter 9
2
Tighten four M4 x 6 mm screws.
3
Place each door frame on front edge of chassis
and immediately under the cable management
area.
Figure
9-22).
Replacement Procedures
OL-23069-06