Complete The Finished Wall; Clean-Up After Installation - Kohler System II K-712-H Installation Manual

9. Complete the Finished Deck
- If you have not already done so, carefully remove the protective tape from the whirlpool rim.
- Cover the framing with water resistant deck material. Seal the joints between the whirlpool rim edge and the
water resistant deck material with silicone sealant.
- Tape and mud the water resistant deck material. Install the finished deck to the water resistant deck material. Seal
the joints between the whirlpool rim and the finished deck material with silicone sealant.
- Install the faucet trim according to the instructions packed with the trim.

10. Clean-Up After Installation

- When cleaning up after installation, do not use abrasive cleansers, as they may scratch and dull the whirlpool
surface. Use warm water and a liquid detergent to clean the surface.
- Remove stubborn stains, paint, or tar with turpentine or paint thinner. Do not allow cleaners containing
petroleum distillates to remain in contact with any whirlpool surfaces for long periods of time. Remove plaster
by carefully scraping with a wood edge. Do not use metal scrapers, wire brushes, or other metal tools. Use a
powder type detergent on a damp cloth to provide mild abrasive action to any residual plaster.
B
1011606-2-
Finished
Deck
Material
Apply silicone
sealant to the edges
of the water-resistant
deck material and
the finished deck
Water-Resistant
Deck Material
Framing
Whirlpool
8
Kohler Co.