Table Of Contents - Kohler System II K-712-H Installation Manual

Important Information
WARNING: When using electrical products, basic
precautions should always be followed, including
the following:
DANGER: Risk of electric shock. Connect only to a
circuit protected by a Ground Fault
Circuit Interrupter (GFCI).
Building materials and wiring should be routed away from the
pump body and other heat producing components of the unit.
Install to permit access for servicing.
Grounding is required. The unit should be installed by a
qualified service representative, and grounded.
Electrical Requirements
The installation must have a Class A Ground Fault
Circuit Interrupter (GFCI). The GFCI protects against
line to ground shock hazard. Use a 120 V, 20 A, 60 Hz
dedicated service for the whirlpool.
Product Notices
WARNING: Unauthorized modification may cause
unsafe operation and poor performance of the
whirlpool. Do not relocate the whirlpool pump, or
make other modifications to the whirlpool system, as
this could adversely affect the performance and safe
operation of the whirlpool. Kohler Co. shall not be
liable under its warranty or otherwise for personal
injury or damage caused by any such unauthorized
modification.

Table of Contents

Thank You . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Before You Begin . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Recommended Tools and Materials
Prepare the Site . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Prepare the Whirlpool . . . . . . . . . . . . . . . . . . . . . . . . .
Install the Whirlpool . . . . . . . . . . . . . . . . . . . . . . . . . . .
Cut the Pump Banding Straps
Install the Plumbing and Grip Rails
Make Electrical Connections
Install the Whirlpool Trim Kit
Test Run the Whirlpool . . . . . . . . . . . . . . . . . . . . . . . . .
Complete the Finished Wall
Clean-Up After Installation
Confirm Proper Operation
Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
B
1011606-2-
. . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . .
WARNING: Risk of electrical shock. A
licensed electrician should make all electrical
connections.
WARNING: Risk of electrical shock.
Disconnect power before servicing.
WARNING: Risk of injury or property
damage. Please read all instructions
thoroughly before beginning installation,
including the following requirements.
NOTICE: Follow all local plumbing and electrical
codes.
Factory-Assembled Features
Factory installed components include pump with
integral heater, control, switch, and power supply cord.
No installation is needed.
The whirlpool pump and piping are factory assembled.
Connections and Service Access
Before installation, ensure proper access to the final
connections.
NOTICE: Provide unrestricted service access to
the pump. You must provide access for servicing
the pump and controls. The access must be
located immediately next to the pump. Study the
roughing in information packed with the
whirlpool.
3
3
3
4
4
5
5
6
6
7
7
8
8
9
10
2
Kohler Co.