CITROEN Berlingo Electric Handbook page 23

Disconnection
The charging lamp in the
instrument panel going
off and the fl ashing of the
green CHARGING lamp in
the controller indicates that
charging is complete.
- Press the button to release the
charging plug,
- refi t the protective cover on the
charging cable,
- close the socket cover, then the
access fl ap,
- disconnect the controller end of
the charging cable from the power
point,
- stow the charging cable.
After charging
- Ensure that the socket cover
and access fl ap are closed.
- Take car to avoid the entry of water
or dust into the socket, under its
cover or in the charging plug (risk
of fi re or electrocution).
- Do not leave the cable connected
to the power point (risk of short-
circuit or of electrocution in the
even of contact with or immersion
in water).
- Do not dismantle or modify the
vehicle's charging socket or
charging cable (risk of fi re).
Take care of the cable and its
control unit
- Do not tread on it, submerge it
in water, pull on it, or subject it to
impacts. If the charging cable or its
control unit is damaged or worn, do
not use it.
- To replace it, contact a franchised
dealer or a qualifi ed workshop.
- The same applies for an impact,
even if light, against the charging
access fl ap or the cover.
With the charging completed by
the cable connected, opening the
driver's door restarts charging for
around 20 seconds.