Firmware Versions - Samson 3730-1 Mounting And Operating Instructions

2.3 Firmware versions

These Mounting and Operating Instructions are valid for firmware versions 2.20 to 2.29. The
revisions listed in the table apply to firmware version 2.02 and higher.
Table 1: Firmware revisions
2.02 (old) 2.10 (new)
New Reset function in Code P0. See section 11.3.
New Manual mode function in Code P14. See section 11.3.
2.10 (old) 2.11 (new)
Internal revisions
2.11 (old) 2.12 (new)
Internal revisions
2.12 (old) 2.20 (new)
• Parameter change: Nominal range (P4)
• New assignment of parameter codes: Manual mode (P17) and Reset (P18)
• New parameter codes: Firmware version (P20) and Control mode (to include
integral-action component, P21). See code list on page 82 onwards.
• New assignment of error codes E8 to E15. See error codes on page 85 on-
wards.
2.20 (old) 2.21 (new)
Optimized detection of zero and initialization routine
2.21 (old) 2.22 (new)
• P12 (limit A1) and P13 (limit A2) parameters: adjustment ranges extended to
0-100 % (same behavior as in firmware 2.20). See section 11.3.
• P4 parameter (nominal range): adjustment ranges extended. See code list in
section 11.3.
EB 8384-1 EN
Safety instructions and measures
13