Table of Contents
Advertisement
1. Connecting the video recorder
Preparing the remote control for
operation
The remote control and its batteries are packed
separately in the original video recorder packag-
ing. You must install the batteries in the remote
control before use.
1.
1.
Take the remote control and the enclosed
batteries (2 batteries).
2.
2.
Open the remote control's battery compart-
ment and place the batteries in it as shown in
the picture and close the battery compart-
ment.
The remote control is now ready to use. Its
range is approximately 7 metres.
Connecting your video recorder to
the TV
The necessary cable connections must be made
before you can record or playback TV pro-
grammes using your video recorder.
We recommend that you
use a scart cable to con-
nect your TV and video
recorder.
What is a scart cable?
The scart or Euro AV cable serves as the uni-
versal connector for picture, sound and control
signals. With this type of connection, there is
practically no loss of quality during the picture
or sound transfer.
• You can have the Hi-Fi sound on the TV only
with a scart cable.
Connecting with a scart cable
Have the following cables ready:
- One aerial cable (1, supplied)
- One scart cable (2, not sup-
plied)
1.
1.
Remove the aerial
cable plug from your
TV. Insert it into the
AERIAL at the back
of the video recorder.
2.
2.
Insert one end of the
supplied aerial cable
into the RF OUT at
the back of the video
recorder and the
other end into the
aerial input socket at
the back of the TV.
3.
3.
Plug one end of a scart cable into the scart
socket AV1(TV) at
the back of the video
recorder and the
other end into the
suitable scart socket
on your TV reserved
for the video recorder operation (see your
TV's operating instructions).
4.
4.
Switch on the TV.
5.
5.
Insert AC cable into the wall socket.
My TV has several scart sockets. Which one
should I use?
Select that scart socket which is suited for the
video output as well as for the video input.
My TV has a configuration menu for the
scart socket.
Please configure this scart socket as Input-
Output.
6.
6.
If the connection was properly made and
your TV was automatically switched to the
programme number for the scart socket, you
will see the following picture:
PUSH MENU TO CONTINUE
4
1
AERIAL
AV 1 (TV
)
AUD IO
OUT PUT
L
AER IAL
RF OU T
R
)
AV 1 (TV
RF OUT
AUD IO
OUT PUT
L
AER IAL
RF OU T
R
1 (TV )
AUD IO
OUT PUT
L
AER IAL
AV1 ( TV )
RF OU T
R
2
EN
Advertisement
Table of Contents
