Removal Of The Cover / Product Care - CYBEX Sirona Short Manual

11
10
37
15
REmOvAL OF THE COvER
the cover consists of five components fastened to the seat shell by elastic pipings,
Velrco® strip and zipper. once you have released all the fastenings, you can remove
the individual components for washing.
noTE! Before detaching the cover please pull out the elastic pipings under silver
decorative parts in order not to tear it.
in rearward-facing use proceed as follows:
• open the belt buckle (11) of the 5-point belt system.
• Remove the shoulder pads (15).
• now thread the shoulder belts (10) out of the cover.
• you can now remove the cover by drawing it forwards.
• Re-apply the cover carry out the steps in the reverse order.
PRODuCT CARE
To guarantee that your child seat provides the maximum protection, it is
essential to comply with the following points:
• all major components of the child seat must be regularly checked for damage.
the mechanical parts must work without problems.
• it is essential to make sure that the child seat is not jammed between hard parts
such as the car door, seat rails etc, which can damage it.
if e.g. the child seat is dropped, it must be tested by the manufacturer before being
used again.
!
Warning! the cover is an integral component of the cyBex SiRona
safety design. the child seat must therefore never be used without the
cover.