Tripp Lite BP480V09 Owner's Manual page 5

2. Installation and Setup
Removing Battery Connector Cover and Installing Battery Cable Bracket
1. Unscrew the screws securing the cover of the battery pack's UPS DC connector. Remove cover and save screws for step 4.
Note: The UPS DC connector is located on the left side.
2. Attach the cable bracket to the battery cable
3. Connect the external battery connector to battery pack
Notes:
• Make sure the cable is fully inserted into their connectors.
• Small sparks may result during battery connection; this is normal.
• Be sure to connect the protective earth wire ring terminals to the earth bonding screw on each cabinet.
4. Use the two screws removed in step 2 to secure the battery cable to the battery pack cabinet
Bracket
C
.
A
.
B
C A
C
B
5
.