Routine Cleaning - Stoelting SO218B Operator's Manual

D. Put a small amount of spline lubricant on the hex
end of the auger shaft. A small container of spline
lubricant is shipped with the machine.
D. Install the plastic auger blades onto the auger.
E. Push the auger into the freezing cylinder and
rotate it slowly until the auger engages the drive
shaft.
F. Insert the spigot body into the front door.
G. Install the support bushing onto the auger.
H. Install the front door onto the machine.
I. Install the knobs on the machine studs.
J. Look for the proper seal between the freezing
cylinder, o-ring, and front door.
Operators Manual #513679 Rev.1
K. Insert the spigot handle so the hole lines up and
insert the spigot pin.
L. Install the hopper cover, drain tray, drip tray, and
drip tray grid.
The machine is assembled and ready to be sanitized.
3.12 CONSISTENCY ADJUSTMENT
The consistency adjustment screw is located behind the
right side panel near the back. Remove the black plug to
access the screw. To adjust consistency use a fl at head
screwdriver. Turn clockwise for thicker product and coun-
terclockwise for thinner product. Allow 15-30 minutes for
the consistency change to show up in the product.

3.13 ROUTINE CLEANING

To remove spilled or dried mix from the machine exterior,
wash in the direction of the fi nish with warm soapy water
and wipe dry. Do not use highly abrasive materials as
they mar the fi nish.
10 SO218B Model Machine