Table of Contents
Advertisement
3.1 OPERATOR'S SAFETY PRECAUTIONS
SAFE OPERATION IS NO ACCIDENT; observe these
rules:
A.
Know the machine. Read and understand the
Operating Instructions.
B.
Notice all warning labels on the machine.
C.
Wear proper clothing. Avoid loose fi tting garments,
and remove watches, rings or jewelry that could
cause a serious accident.
D.
Maintain a clean work area. Avoid accidents by
cleaning up the area and keeping it clean.
E.
Stay alert at all times. Know which switch, push
button or control you are about to use and what
effect it is going to have.
F.
Disconnect electrical cord for maintenance. Never
attempt to repair or perform maintenance on the
machine until the main electrical power has been
disconnected.
G.
Do not operate under unsafe operating conditions.
Never operate the machine if unusual or excessive
noise or vibration occurs.
Operators Manual
#513679
SECTION 3
INITIAL SET-UP AND OPERATION
Figure 3-1 Controls
Rev.1
3.2 OPERATING CONTROLS AND INDICATORS
Before operating the machine, it is required that the op-
erator know the function of each operating control. Refer
to Figure 3-1 for the location of the operating controls on
the machine.
WARNING
High voltage will shock, burn or cause death. The
OFF-ON switch must be placed in the OFF position
prior to disassembling for cleaning or servicing. Do
not operate machine with cabinet panels removed.
A.
Spigot Switch
The spigot switch automatically starts the auger
drive and refrigeration systems when the spigot is
opened to dispense product. When the spigot is
closed, the drive motor and compressor remain on
until the product in the freezing cylinder reaches
the proper consistency..
B.
CLEAN-OFF-ON Switch
The CLEAN-OFF-ON switch is used to supply
power to the control circuit. When the switch is in
the OFF (middle) position, power is not supplied
to the control board or refrigeration system. When
5
Diagnostic
Light
Add Mix
Indicator
Clean/Off/On
Switch
SO218B Model Machine
Advertisement
Table of Contents
