Table of Contents
Advertisement
Clean Rear
Seal Surface
F.
Clean the rear seal surfaces from the inside of
the freezing cylinder with the 90° to 110°F (32°
to 43°C) cleaning solution.
3.10 SANITIZE MACHINE
CAUTION
Do not allow sanitizer to remain in contact with
stainless steel parts for prolonged periods. Pro-
longed contact of sanitizer with machine may cause
corrosion of stainless steel parts.
A.
Use Stera-Sheen or equivalent sanitizing solution
mixed according to manufacturer's instructions
to provide 100 parts per million strength solution.
Mix sanitizer in quantities of no less than 2 gallons
(7.5 liters) of 90° to 110°F (32° to 43°C) water.
Any sanitizer must be used only in accordance
with the manufacturer's instructions.
B.
With the large brush provided, sanitize the rear
of the freezing cylinder by dipping the brush in
the sanitizing solution and brushing the rear of
the cylinder.
3.11 ASSEMBLY OF MACHINE
To assemble the machine parts, refer to the following steps:
Petrol Gel sanitary lubricant or equivalent must be
used when lubrication of parts is specifi ed.
The United States Department of Agriculture and
the Food and Drug Administration require that lubri-
cants used on food processing equipment be certi-
fi ed for this use. Use lubricants only in accordance
with the manufacturer's instructions.
Operators Manual
#513679
NOTE
NOTE
Rev.1
A.
Assemble all o-rings onto the parts dry, without
lubrication. Then apply a thin fi lm of sanitary
lubrication to the exposed surfaces of the o-rings.
Also apply a thin fi lm of sanitary lubricant to the
inside and outside of the front auger support
bushing.
B.
Assemble the rear seal adapter onto the auger
with the spring facing towards the front. Be sure
the o-ring is in place before installing the assembly.
C.
Assemble the o-ring into the rear seal and
assemble the seal onto the auger. DO NOT
lubricate the rear seal o-ring.
9
Do Not
Lubricate
O-Ring
SO218B Model Machine
Advertisement
Table of Contents
