Maintenance And Cleaning; Cleaning Lint Filter / Loading Door Inner Surface; Cleaning The Sensor - Beko DE 8433 PA0W User Manual

6

Maintenance and cleaning

Service life of product extends and frequent-
ly experienced problems will be reduced if it
is cleaned at regular intervals.
6.1 Cleaning Lint Filter /
Loading Door Inner Surface
Lint and fibre released from the laundry to
the air during the drying cycle are collected in
the Lint Filter.
C
Such fibre and lint are generally
formed during wearing and wash-
ing.
A
Always clean the lint filter and the
inner surfaces of the loading door
after each drying process.
C
You can clean the lint filter hous-
ing with a vacuum cleaner.
To clean the lint filter:
• Open the loading door.
• Remove the lint filter by pulling it up and
open the lint filter.
• Clean lint, fibre, and cotton raveling by
hand or with a soft piece of cloth.
• Close the lint filter and place it back into
its housing.
• A layer can build up on the filter pores
that can cause clogging of the filter after
using the dryer for a while. Wash the
lint filter with warm water to remove
the layer that builds up on the lint filter
surface. Dry the lint filter completely
before reinstalling it.
Dryer / User Manual
• Clean the entire inner surface of the
loading door and loading door gasket
with a soft damp cloth.

6.2 Cleaning the sensor

There are dampness sensors in the dryer
that detect whether the laundry is dry or not.
To clean the sensors:
• Open the loading doorof the dryer.
• Allow the machine to cool down if it is
still hot due to the drying process.
• Wipe the metal surfaces of the sensor
with a soft cloth, dampened with vinegar
and dry them.
55 / EN