Download
Share
Print this page
Danfoss BasicPlus2 WT-DM Installation Manual
  1. Manuals
  2. Brands
  3. Danfoss Manuals
  4. Thermostat
  5. BasicPlus2 WT-DM
  6. Installation manual

Danfoss BasicPlus2 WT-DM Installation Manual

Hide thumbs Also See for BasicPlus2 WT-DM:

Advertisement

Quick Links

Download this manual
Installation Guide
BasicPlus
WT-DM
2
Room thermostat

Advertisement

loading

Related Manuals for Danfoss BasicPlus2 WT-DM

Summary of Contents for Danfoss BasicPlus2 WT-DM

  • Page 1 Installation Guide BasicPlus WT-DM Room thermostat...

  • Page 2: Installation Steps

    Wiring 1. Dimensions, see g.4. 2. Wiring diagram,see g.5. (S1,S2: oor sensor terminals;A+,B-: Modbus communication terminals). 3. WT-DM is often used with Danfoss TWA actuator. Depending on the conditions of power location and actuator type (NC or Danfoss Heating Solutions...
  • Page 3 NO), the wiring between room thermostat and actuator is dif- ferent.Follow the illustrations to complete the wiring: 1. When power supply location is close to room thermostat: type,see g.6. type,see g.7. type,see g.8. type,see g.9.

  • Page 4: Technical Specifications

    Technical Specifications Communication protocol Modbus RTU Communication interface RS485...
  • Page 5 安装指南 WT-DM 安装说明书 必须由经过专业培训合格的电工进行安装。 2. 室内温控器应当安装在地面上方大约1.5米处，并且避免 受到日光、气流或者其他热源（例如：电视）的影响。 请见图1。 在将背板固定至暗线箱之前，使用随附的螺钉连接导 线，然后将盖子安装至背板。请见图...
  • Page 7 通讯协议 Modbus RTU 通讯接口 RS485...
  • Page 8 Fig. 1 Fig. 2 Fig. 3 Danfoss Heating Solutions...
  • Page 9 Fig. 4 86.0 16.0 24.5 46.2 Fig. 5 Floor Sensor Modbus Communication 230 V ~ Fig. 6 WT-DM 230V L NO NC N A+ B- S1 S2 230 V ~ Danfoss Heating Solutions...
  • Page 10 NO NC N A+ B- S1 S2 230 V ~ Fig. 8 WT-DM 230V NO NC N A+ B- S1 S2 230 V ~ Fig. 9 WT-DM 230V NO NC N A+ B- S1 S2 230 V ~ Danfoss Heating Solutions...
  • Page 11 Floor Heating Hydronics Ulvehavevej 61 VICUM12P Produced by Danfoss Floor Heating Hydronics 05/2015...