Installing The Batteries - IBM WorkPad Handbook

Contrast
control
Battery door
Serial port door Protects the serial port that fits into the

Installing the Batteries

To use your WorkPad, you must install two AAA alkaline batteries.
The batteries fit behind the battery door on the back of the WorkPad.
To install the batteries in your WorkPad:
1. Press the latch on the battery door and lift the battery door away
from the WorkPad.
2. Install the two AAA alkaline batteries supplied with your
WorkPad into the battery compartment.
Chapter 1
Adjusts the appearance of the screen for the
clearest screen display. Depending on the
lighting conditions or temperature of the
environment where you use your WorkPad,
you may need to adjust the setting of the
contrast control.
Covers the batteries that power your
WorkPad. See "Installing the Batteries" for
information on removing the battery door and
installing batteries.
connector of the WorkPad cradle to ensure
that the connection surface of the serial port
remains clean and clear of debris.
Press tab
to open
Page 5