Sony NSP-100 Operating Instructions Manual page 11

In this case, skip to step 14.
• If you select "Fixed," the screen changes as
follows.
In this case, advance to step 9.
9
Using the v and V buttons, select the item you want
to set, then press the ENTER button.
The setting can now be changed.
10
Using the b and B buttons, select the group to set
within the selected item.
11
Enter the setting with the numeric buttons (0 to 9).
Alternatively, adjust the setting with the v and V
buttons.
For details of the settings to be entered, consult
your system administrator.
12
Press the ENTER button.
This confirms the setting of the selected item.
13
Repeat steps 9 to 12 until all of the required items
have been set.
14
Press the MENU button.
To enable the new network settings, a message
prompt appears, asking if you want to reset the unit.
15
Select "Yes" to reset immediately or "No" to reset
later, then press the ENTER button.
The standby screen appears after a reset (for "Yes")
or immediately (for "No").
To change the design of the standby screen
Use the BZNP-100 Software.
For details, refer to the Help information for the BZNP-
100 Software.
Starting Up and Initial Settings
11