GE AEV07KP Use & Care Manual page 14

Window type
Table of Contents

Advertisement

Cooling Descriptions
For Normal Cooling–Select the Cool mode and High or Turbo fan with a middle set temperature.
For Maximum Cooling–Select the Cool mode and Turbo fan with a lower set temperature.
For Quieter & Nighttime Cooling–Select the Cool mode and Low fan with a middle set temperature.
Energy Saver Mode
The fan will cycle on and off with the compressor. This results in wider variations of room temperature and
humidity
Normally used when the room is unoccupied.
NOTE:
The fan may continue to run for a short time after the compressor cycles off and fan will cycle on and off.
Fan Only Mode
Use the Fan Only Mode at Low, High, Turbo fan speed to provide air circulation and filtering without cooling.
Since fan only settings do not provide cooling, a Set temperature cannot be entered. The room temperature
will appear in the display.
NOTE: Auto Fan Speed cannot be used when in the Fan Only Mode.
Auto Fan Speed
Set to Auto fan speed for the fan speed to automatically set to the speed needed to provide optimum
comfort settings with the set temperature. If the room needs more cooling, the fan speed will automatically
increase. If the room needs less cooling, the fan speed will automatically decrease.
NOTE: Auto Fan Speed cannot be used when in the Fan Only Mode.
Changing batteries and notices
1. Slightly to press the place with
back cover of wireless remote control. (As show in figure)
2. Take out the old batteries. (As show in figure)
3. Insert two new AAA1.5V dry batteries, and pay attention to the polarity. (As show
in figure)
4. Attach the back cover of wireless remote control. (As show in figure)
NOTE:
• When changing the batteries, do not use the old or different batteries, otherwise,
it can cause the malfunction of the wireless remote control.
• If the wireless remote control will not be used for a long time, please take them
out, and don't let the leakage liquid damage the wireless remote control.
• The operation should be in its receiving range.
• It should be placed at where is 1m away from the TV set or stereo sound sets.
• If the wireless remote control can not operate normally, please take them out, after 30s later and
reinsert, if they cannot normally run, please change them.
12
Operation Procedure
, along the arrowhead direction to push the
2
1
3
4
Sketch map for
changing batteries

Advertisement

Table of Contents
loading

Table of Contents