In-Car Connection - Philips SA10717 User Manual

XP SA 107/17 11-07-2000 11:11 Pagina 20

IN-CAR CONNECTION

IN-CAR USE (CONNECTIONS SUPPLIED OR OPTIONALLY
AVAILABLE)
Only use the supplied car voltage converter (4.5 V, DC, positive
pole to the center pin) and the car adapter cassette. Any other
product may damage the set.
1 Put the RUSH on a horizontal, vibration-free and stable
surface. Make sure it is a safe place, where the player is
not a danger or obstacle to the driver and passengers.
2 Connect the DC plug of the voltage converter to the 4.5V DC
jack of the RUSH.
20
3 Insert the voltage converter into the cigarette lighter jack. If
4 Turn down the volume and connect the adapter cassette
5 Carefully insert the adapter cassette into the car radio's
p
6 Make sure the cord does not hinder your driving.
7 Start the RUSH, set VOL to 8 bar and adjust the sound with
• Always remove the voltage converter from the cigarette
4.5 V DC
Notes:
– Avoid excessive heat from the car heating or from direct
– If your car radio has a LINE IN jack, use the LINE IN jack for
necessary, clean the cigarette lighter jack to obtain a good
electrical contact (only for a 12 V car battery, negative
grounding).
plug to the p jack of RUSH.
cassette compartment.
the car radio controls.
lighter jack when the RUSH is not in use.
sunlight (e.g. in a parked car in the summer).
the car radio connection instead of the adapter cassette.
Connect the signal lead to this LINE IN jack and the p jack
of the RUSH.