Connecting Rush To Your Computer - Philips SA10717 User Manual

XP SA 107/17 11-07-2000 11:11 Pagina 15

CONNECTING RUSH TO YOUR COMPUTER

Depending on your PC, you can choose one of 2 ways to
connect RUSH to your computer.
• Parallel port option (see Fig. 3)
Follow steps 1-4 below.
• USB port option (see Fig. 4)
Follow step 3, but connect the port/USB cable to the
computer's USB port and the set.
1 Make sure your computer and the set are switched off.
2 If a printer cable is connected to the parallel port on your
computer, disconnect the printer cable.
3 Connect the supplied parallel cable to the computer's
respective port. Remove the protective rubber seal from the
DATA I/O jack on the set, then insert the other end of the
cable to DATA I/O.
• IMPORTANT:
– To avoid damage to the set, check the other end of the
cable is the right way up, with the side marked TOP
facing up, before you insert this cable end to DATA I/O.
– Always replace the protective rubber seal when not
connecting RUSH to your computer. Keep the seal in the
carrying pouch or a safe place when removed from the
DATA I/O jack.
4 Turn on the set first, then turn on your computer.
Fig. 3
Fig. 4
15