Table of Contents
Advertisement
Windows NT
Windows NT 4.0 Setup
After installing the HomeLink hardware in your
computer, follow these instructions for installing
the network driver in Windows NT 4.0. The instal-
lation procedure for the network driver will vary
slightly depending on the version of Windows NT
you are using, the service packs you have
installed, and your current system configuration.
In the type of network that we will be building,
there are two kinds of computers - clients and
servers. Servers are the "mother" computers while
the clients are the "children". Servers handle all of
the administrative duties on the network, while
clients route all of their communications through
the server. The server is usually the fastest and
most powerful PC on the network, but it doesn't
have to be.
Please note that the NT installation does not auto-
matically install the WinGate Home software onto
your computer. When you are finished with the
NT installation, reboot your PC and run the
WinGate installation program on the CD-ROM at
the path D:\wingate\wingate.exe.
Throughout the NT installation, it is assumed that
the drive letter of your CD-ROM drive is D. If
your CD-ROM drive is designated as any other
letter, use the correct letter instead of D.
If, at any time during the installation, you are
unsure about how to answer a specific question,
consult your system administrator or NT 4.0 docu-
mentation before you continue.
34
Advertisement
Table of Contents
